Neon tube Transformers are sized by the length of the tube. These types of transformers operate at voltages from 5,000 to 20,000 volts. If the length of the two tube sections are within the range of the transformers then two tubes can be connected together.
you want to wire the batteries in series...connect negative of one battery to positive of the other. You then use the two remaining terminals as youe - and + 12v source
one or two i think
You need two windings because that is the purpose of the transformer - to convert one voltage into another. If there were only one winding, it would be an inductor, or a special case called an autotransformer, but that is still "sort of" two windings.AnswerThe major advantage of a two-winding transformer (a 'mutual transformer') over a single-winding transformer (an 'autotransformer') is that a two-winding transformer provides electrical isolation between the secondary and primary circuits. This is very important for safety reasons and there are many circumstances in which the use of an autotransformer is not permitted.
Neon in pure form is colorless because it is a gas. It is one of the elements that are hand to find on earth and it is among the noble gases.
Watts are power. If the lights were mostly or totally switched off, you'd have a circuit generating 600W of heat somewhere if the transformer still took 600W, not only that, but when you switched on, the 600W that the transformer was consuming, would not disappear, so the total drain would be 1.2kW. ---- Don't understand the above answer. The 600 watts on the transformer nameplate is the maximum amount of wattage that the transformer can produce and still be within its safety limits. It doesn't draw that wattage all the time. If you had two 50 watt lamps connected to the transformer then the transformer has the capacity of 500 watts left. The transformer will only produce the wattage that the load requests. The transformer has the ability to supply twelve 50 watt bulbs. 12 x 50 = 600. Any more bulbs than 12 and the transformer is in an overload condition.
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
They are magnetically coupled--a current in one circuit induces a current in the other one in both a transformer and an induction motor.
There are two types of transformers:- 1. Step-up transformer & 2. Step-down transformer. A transformer used to increase the voltage is called Step-up transformer. A transformer used to decrease the voltage is called Step-down transformer. Uses of step-up transformer:- in power supply stations, in picture tubes of TV, computer monitors, halogen lights, etc. Uses of step-down transformer:- in supply of electricity to homes, in the power supply to the low voltage devices like radio, music systems which are run by AC mains.
You can if you want to connect two 12 volt lights in series with each other. Make sure that the 12 volt lights are rated for AC and not DC.CommentFurther to the above answer, you must also ensure that the two lamps have identical power ratings, or the lamp with the lower power rating will be brighter than the one with the higher power rating!
Period number = no. of electron shells. Therefore neon has two shells.
The symbol for neon comes from the first two letters of the element Neon.
if you're talking about the stock gauges as in the tach or speedo, two options one stretched or pinched cables, two if your talking about the misc. bs lights that pop up as gauges probably a ground