Depends.
Some smaller stuff can usually run on both, in which case it will be printed on them.
If it isn't, you can't run a 220v item on 110v.
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.
It would involve some electronics work but it could be done. Might add that it could be more expensive than just buying the proper power supply. Use Use 220V 60hz motor to run 110V 50hz Generator.
You can but it would be wise not to. Most 60hz appliances will not work at 50 Hz. <<>> Yes, no problem at all. The frequency does not enter into the equation because the hot plate is a strictly resistive load.
no way because frequency cannot change
Not really because motors are designed to run at either 50 or 60 Hz and the wrong frequency might cause them to malfunction or overheat.
No. For more information see the answers to the Related Questions shown below.
you can't
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.
Yes, no problem.
nothing
Depending on the device, it may or may not work. And if it works, it won't work properly. A 60Hz devices needs 60 cycle current, not 50.
It would involve some electronics work but it could be done. Might add that it could be more expensive than just buying the proper power supply. Use Use 220V 60hz motor to run 110V 50hz Generator.
No, 120 v is not enough.
No
Do you mean definition? If so 110V = 110 volts-60hz = 60 hertz. Hertz is the cycles that the electricity runs at. 60hz. is the US standard. Europe is at 50hz.
Yes no problem the transformer should run a little cooler as well.
Yes, using a 220v-60hz microwave in Australia is fine. The voltage of alternating current supplied to homes in Australia is 220v. The frequency of the voltage is 50hz.