Welding should only be done between similar metals. Installing welded flanges to connect two dissimilar metals would be the preferred method of connection.
circumfrencial weld is sometimes referred to as Girth weld. its just another term.
Sure why not its the same as welding it to a straight piece of pipe
Furnace butt welded pipe refers to the manner in which a pipe is to be welded. The skelp itself is heated to a specific temperature in a furnace. You would then weld the longitudinal seam forge. This is a method that works on fence posts or pipes required for low pressure services.
National Association for Corrosion engineers- NACE is the material (CS or SS) used in specific application/service where high corrosion occure due to sulpher/hydrogen embrittlment. e.g. generally NACE material is used in salty environment i.e. offshore equipments .Sanjay RathodIOTDE
One method is Ultra Sonic Sound, another Die Penetration.
Welding should only be done between similar metals. Installing welded flanges to connect two dissimilar metals would be the preferred method of connection.
Pipe that meets the requirements of sour gas service per NACE MR0175.
Gi weld not recommended . Because of gi coationg will be spoiled out . Puncture will be occur on the pipe weld .
Very likely to leak, zinc in the GI pipe will be contaiminating the weld and thus you cannot get a good weld.
A weldolet is a fitting you weld on a (run) pipe, and then butt weld a branch pipe to it. A tredolet is a fitting you weld on a (run) pipe, and then screw a threaded branch pipe to it. Some people call this a threadolet A sockolet is a fitting you weld on a (run) pipe, and then socket weld a branch pipe to it. A nipolet is the same as a weldolet or thredolet but has an elongated branch connection. You have to specify if it's a welded or threaded nipolet.
The pipe must be fixed (not rolled) in the horizontal position. With the pipe horizontal, the weld is vertical. The pipe being fixed requires the welder to weld flat (top), vertical (sides), and overhead (bottom). The pipe must be fixed (not rolled) in the horizontal position. With the pipe horizontal, the weld is vertical. The pipe being fixed requires the welder to weld flat (top), vertical (sides), and overhead (bottom).
wildly welding main pipe the are fillet weld or butweld
CS Normal pipe will be meeting the Specification (ASTM/ASME) standard requirements. NACE Pipes will be having additional restriction in Chemical Composition,Hardness,Carbon Equivalent and Heat treatment requirements.This additional requirements to ensure the usability of material in Sour services.
A butt weld is where the diameter of the pipes welded together are the same, a socket weld is where a larger diameter pipe is fitted into a smaller one. In making a butt weld, the pipes (or pipe and fitting) usually have an angle machined or ground into the outside corner, so when they are placed together face-face, there is a circumferential V shaped gap serving as the weld prep. In a socket weld, the pipe is inserted into the socket, backed off slightly to make a gap between the end of the pipe and the bottom of the socket, and the weld is made around the outside diameter of the socket to the outside diameter of the pipe. The gap at the bottom of the pipe prevents thermal expansion from stressing the joint during or after welding.
circumfrencial weld is sometimes referred to as Girth weld. its just another term.
Depends....clamp or weld.
root pass