no
Question is incorrect. in a 240 Volt single phase circuit, how can you have A phase and B phase?
If the heater is rated as a 3 phase 480 volt heater then a neutral is not needed. If the voltage stated is 277 volts three phase then a neutral is needed.
No you need a Roto Phase
yes but voltage will be out a little.This ok for something like a heater which wont care.But for an electric motor starting and overheating maybe a problem.In the US this would be 220v single phase and 208 volts 3 phase.
Yes it would work pretty well but it might not meet its accuracy specification.
For a 240-volt single-phase induction motor, a two-pole motor starter is typically required, as it connects to the two live conductors of the single-phase supply. For a 440-volt three-phase induction motor, a three-pole motor starter is needed, as it connects to the three phases of the three-phase supply.
120 volt single phase rectifies to about 96 volt DC
220 volt single phase from 480 volt 3 phase that one wire taken one phase and second wire connected in earth point. we get 220 v The above answer is incorrect, one phase from a three phase 480 volt system will give you 277 volts to ground. You must use a transformer to get the voltage you need.
You can not change it. 440 volt is by design. However you run it with 220 single phase supply, but it would run far lower power.
US homes use a 240 volt single phase 'Edison' system. It is a 3-wire (4 with the ground) system. Phase to phase measures 240v, while each phase to neutral measures 120v.
A single phase 600 to 240 Volt transformer using two phases of the three phase primary.
All my experience with rotary phase converters have been in converting 240 volt single phase into 240 volt three phase. They all were hard wired into their respective systems, so my answer is no.