Too much current flowing in circuit. Sounds like a voltage was applied that exceeded the rating of the resistor. Resistors are rated in watts which is Volts times Amps. As an example, you might have a 1/2 watt rated resistor. If you applied 120 VAC across a 10 Ohm resistance then the current would be 12 Amps. The wattage would be 1,440 watts which is well in access of the rating and would certainly burn out the resistor.
something like burnout dominator or burnout revenge
The last burnout game was burnout crash, but it was not a proper burnout game, and was a spin off of the burnout series. The last actual burnout game was burnout paradise.
linear and non-linear resistor
Burnout dominator came out before burnout paradise. Burnout revenge was later recreated, but was not the last burnout game before burnout paradise.
burnout dominator
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
Yes, a resistor has two sides, and furthermore they are interchangeable.
A heater fan that runs anytime the key is on is usually caused by a failed blower resistor. The blower resistor is located behind the glove box door. You open the glove box and pull inward on the stop bumpers on the sides to remove door. Look in and you will see two plugs on the resistor. Unplug them, remove two screws, and remove the resistor.
You can buy all burnout games for ps2 besides paradise and legends. Here is a list of all the ones you can buy; -burnout -burnout 2: point of impact -Burnout 3: takedown -Burnout 4: revenge -Burnout 5: dominator Burnout legends is for psp, and paradise is for xbox, ps3 and pc.
burnout revenge came out first
Burnout Burnout 2 Burnout 3 Buzz series
Get your Burnout License