form_title=Acoustic Ceiling Tile Installation form_header=6373 Why is it necessary for you to install a new ceiling?*= () New construction/Addition () Replacing old ceiling Please select all of the specific characteristics you are looking for.*= [] Standard [] Designer [] Sound absorbing [] Insulation [] Fire rated
Travertine is no more or less tile than ceramic or Porcelain in that application, although it may actually be lighter.. anyone that can install tile on a ceiling could do Travertine..
A drywall ceiling, provides the best type of ceiling for work. It provides a great look, noise level reduction versus a tile ceiling and is inexpensive to install.
To properly install a drop ceiling air vent in your home, follow these steps: Measure and mark the location for the vent in the ceiling tile. Cut a hole in the tile using a utility knife or saw. Attach the vent frame to the tile using screws or clips. Connect the ductwork to the vent frame. Secure the tile with the vent in place back into the ceiling grid. Make sure to follow any specific instructions provided with the vent for proper installation.
One can find cheap tin ceiling tile at several home improvement stores. The Home Depot and Lowes offers these tiles in their stores and will even install it for their customers.
form_title=Acoustic Ceiling Tile Installation form_header=6373 Why is it necessary for you to install a new ceiling?*= () New construction/Addition () Replacing old ceiling Please select all of the specific characteristics you are looking for.*= [] Standard [] Designer [] Sound absorbing [] Insulation [] Fire rated
To replace a ceiling tile with a sprinkler head, first, ensure the water supply to the sprinkler system is turned off. Remove the existing ceiling tile carefully, ensuring not to damage surrounding tiles or fixtures. Install the sprinkler head according to the manufacturer's instructions, typically involving mounting it to a fitting in the ceiling. Finally, replace the ceiling tile around the sprinkler head if necessary, and turn the water supply back on to test the system.
If I am correctly understanding the question. You have a suspended ceiling and wish to add a register. Ok, two ways, the first is easiest. Get a 2`x 2` register and lay it in the grid in the place of a tile. Second, once you have selected the ceiling location for the register, lay the register in the center of the tile where it is going and trace out & cut the hole in the tile to accept the register and reinstall the tile into the ceiling grid and connect the duct. Make sure everything is properly supported and there is no stress on the tile.
I would tile up to the pan where it sits. If you remove it, you will have to tile completely under it so it stays level and raise the drain. If it is in the basement or or over a finished ceiling this can be a problem. If there is a vanity, I would remove it and tile under because is is much less hassle and gives a better result.
Based on my data there is a varying amount of holes in a ceiling tile but the average number is:5162
Whatever the lxw of a single tile is ,divide that into the lxw of the room.
To replace a 12x12 ceiling tile, first, remove the damaged tile by gently lifting it out of the grid. Then, measure and cut a new tile to fit the space. Finally, carefully place the new tile into the grid, ensuring it is securely in place.
The tile was put in place after it was functional, you should be able to remove it with out shutting down the water supply.