If you want to change the brake light, you will need a Torx screwdriver. You will also have to open your trunk and remove the lens cover assembly.
Yes, a blown brake light fuse causes the shift interlock to malfunction. If the interlock can't tell if the brake is depressed or not, it won't shift out of park. The brake light fuse is a 15A in the engine bay fuse box.
Hit the Hazard button it will be a triangled shaped button
The brake light switch in a 2002 Saturn L200 is located above the brake pedal, mounted on the brake pedal assembly. To access it, you'll need to remove the driver's side lower dash cover. The switch is typically adjusted so that it activates the brake lights when the pedal is pressed and deactivates them when released. If you’re troubleshooting issues with the brake lights, checking this switch is a good first step.
there could be a brake light switch located around the brake pedal, this commonly wears out on a Chevy truck The brake sockets are no good There was a campaign for updated brake sockets. Has it been done by a Saturn dealer? If not get it done and you should be fine
The 2001 Saturn L200 uses a 3157 bulb for the tail lights. It's a dual filament bulb, meaning it serves as both the tail light and brake light. Be sure to check your owner's manual or consult with a professional to confirm the specific bulb type for your vehicle.
Could be alarm...
The 2003 Saturn L200 does not have a camshaft position sensor.
You can program the keyless entry remote, for your 2001 Saturn L200, by holding the unlock and lock weapons at the same time. The red light will flash on and off. The remote will be programmed when the red light stays illuminated.
It can cost from $16 to $50 to replace the brakes on a 2001 Saturn L200. This price may change based on part brand and any labor costs at a shop.
2003 Saturn L200 holds 15 gal. of gas.
How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it. How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it.
Have vehicle scanned to have codes cleared