The brake light switch in a 2002 Saturn L200 is located above the brake pedal, mounted on the brake pedal assembly. To access it, you'll need to remove the driver's side lower dash cover. The switch is typically adjusted so that it activates the brake lights when the pedal is pressed and deactivates them when released. If you’re troubleshooting issues with the brake lights, checking this switch is a good first step.
On top of the transmission, just under the battery.
To change the backup light switch on a 2002 Saturn SL2, first, disconnect the negative battery cable to ensure safety. Then, locate the switch on the transmission; it’s typically near the top where the shift linkage connects. Remove the wiring harness from the switch, unscrew the switch using the appropriate tools, and replace it with the new switch. Finally, reconnect the wiring harness, reattach the negative battery cable, and test the backup lights to ensure they function properly.
GM vehicles do not have a fuel shut off/inertia switch
it is located on the light a switch that says 12sec on and off
Where is the backup light switch on a 2002 buick century?
My 2002 Saturn L300 was doing this also, it was the BCM (Body Control Module). Cost about $600 to fix at the dealership
A 2002 Jeep Wrangler does not have a reset switch.
The 2002 Dodge Ram reverse light relay switch is located beneath the drivers side dashboard. The reverse light relay switch will be on the left-hand side of the brake pedal.
brake light switch is above the brake pedal
hazard switch dont lights on
Inside of the Hazard light switch on the dash. A stupid design if you ask me. You have to remove the complete switch. Notice that when you go to an auto parts store, they will not have it listed in their computer. A replacement can be had at a salvage yard or through the dealer - their obvious choice.
The oil pressure light switch is located in the engine compartment on a 2002 Hyundai Santa Fe. It is to the right of the oil filter.