answersLogoWhite

0


Best Answer

If the check engine light is on, then the car is not fine. It may be seem to be running fine, but there is a problem. Damage can occur to the engine, and especially to the 02 sensor and the catalytic converter if the problem is not corrected. The light will be reset with a scan tool after the problem is repaired. There was a recall on the Camshaft sensor, that causes the engine light to come on. You will have to contact the dealer you bought the car from and see where to take the car for warenty work. daewoo's have over 100 sensors on them any of these could set a check engine light. loose gas cap will set a check engine light.could be anything, need to get it scanned to find out. if you unplug the battery all you will do is loose you radio and have to put the code back in, not clear the problem. Pull the codes from the computer, match the code to the troubleshooting procedure, follow the procedure to find the source. Repair the source, light will go out if that was the only problem. There are "monitors" or self tests the computer runs the car through a drive cycle, if a problem occurs, it may not run all of the self tests until that problem is taken care. Therefore, another problem may exist. It is emission related. OR hook up a scanner that is capable of clearing codes, and hope that none are still active. Disconnecting the battery can create other headaches and will not likely solve your dilemma. Best bet is to contact the local snap-on dealer and have him refer you to a known good shop that specializes in this technology-he will know. The " check engine light" is by far one of the most misunderstood technological advances by the public. This is an needed in-depth understanding for the public. It is a warning light that is illuminated when there is a problem affecting the EMISSION SYSTEM only. Emission system being the pollution control system. Don't get a hard on against it as it is a good thing once you understand it. One point that was brought up a a recent meeting of technicians was that the amount of hydrocarbons is greater when the gas cap is left off than when the engine is running. Hydrocarbons are part of pollution emitted as gasoline evaporates. Going a step farther, one facet of the emission system is the "Evaporative" portion. This is when the fumes from the gasoline are leaking from the system into the outside air. This is one part of the emission system that can trigger a check engine light. I would say that about 7% of the vehicles that have a check engine light are the result of a loose or inadequate gas cap. But understand that many scenarios are possible with the "check engine light" The vehicle's powertrain computer (note that some vehicles have 17 different computers) will run a series of self-tests. They will only run under certain criteria. And they can be vastly different from manufacturer to manufacturer. Some self-tests are not run until preceding ones have run successfully. So if there is a problem in one particular area that is preventing another self test from running, you can have a situation where one problem is fixed, but another still exists. If you fix a problem and drive the car through a drive cycle that sets the monitor (or self test) the light will go off as it passes that criteria that triggered it in the first place. After 1996, the auto industry went to a idea called OBD II (on board diagnostics). This was to get all the manufacturers onto a similar plane for troubleshooting and powertrain control. While they still differ vastly, many corrections and adaptations were made for technicians to better fix the check engine light problems. Prior to this there were so many different and poor troubleshooting data from a check engine light problem that resolving the problem was much more difficult. Many early warning light of this nature were set to illuminate based on mileage. An Oxygen sensor was one of the things that were meant to be replaced when that mileage was hit. This is much like many current "Change oil lights

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Check engine light is always on car is fine with no problems is there a way to clear this light other than unplugging the battery for a few minutes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you keep the battery warm during below zero weather?

Of course you could always pull it into a heated garage, But not everybody has that luxury. They sell battery blankets that you can plug in for nights/days you know you might have starting problems on. Of course you could always pull it into a heated garage, But not everybody has that luxury. They sell battery blankets that you can plug in for nights/days you know you might have starting problems on.


Why does the brake light on the dashboured always stay on when you start up your truck?

unhook the battery for a few minutes,then reconnect. should work.


does nextel phone i850 have good battery life?

Yes, the nextel phone i850 has a great battery for a phone this size. You can talk approximately 250 minutes on this phone before it needs to be charged. Batteries can also always be replaced.


Do you need to charge you phone 5 s before set up?

Yes, you should always charge new phones ( Li-Ion Batteries generally) before the first use. You can, however, use it once you have it plugged in because it continues to charge (although at a slower rate) when it is plugged in. All you need to do is make sure the battery is at 100 percent before unplugging it or the battery will run down faster.


Parked car over night in 10-25 degree weather snowing and icy car has always been garaged and always started Now it makes a tapping noise when you try to start it not like a dead battery?

The battery has chilled, it will need to be warmed up. Put it on charge for about an hour or so, then try again. The temperature of the electrolyte, is critical to the efficiency of the Electrolytic process used by the battery to produce power. A cold battery is the No. 1 cause of winter starting problems.


1991 Chevrolet s10 blazer warning brake light always on anybody knows?

If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.


If a car battery dies are you always able to jump it?

No, not always, but in most cases yes. If the battery has a cell that is shorted out it may not jump start.


Reset vw passat dashboard lights always on?

Take off both leads of the battery and leave them off for 2 minutes and then stick the leads back on and it'll reset the computer on the dash.


How do you find out What is killing your battery?

Make sure your Charge Alternator is working and charging your battery properly or else you will always have dead battery. Also avoid corrosion to build up in your battery poles. Make sure your battery poles are not loose and most of all always check water level of your battery.


Why do RC helicopters always run out of battery quick?

small battery big motor


How do you hook up a 1990 ford f150 battery?

Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.


How do you reset the body computer module on a 1994 Plymouth Grand Voyager?

Usually all cars computers will re-set themselves (of trouble codes) after 50 or more start ups. As long as the problems have been repaired. Try disconnecting the battery for at least 10 minutes, that's what I always do for my Chrysler products. Best regards,& Good luck. Tony