It is on the driver side head of the engine.
It goes to the temp gauge which is usually screwed in the head between the manifold on the drivers side, or into the thermost housing on the intake manifold.
180 degree.
how to install the oil pressure gauge on a Chevy 350 small block
The temp gauge sensor screws into the driver side head atoms #2 and #3 plugs. The volt gauge hooks up to any ignition on hot wire and the other wire to chasis ground. Oil pressure gauge is just behind the distributor.
No.
The most effective location for a water temperature gauge on a vehicle is on the head or the side of the block. Generally, water temperature gauges are more accurate and fit better in these locations.
195
Did you ground the sender wire to see if it is the gauge or the sender? Need more help contact me through my board and I will try to help.
It is screewed into the driver's side head, between the first 2 spark plugs
the temp of the intake manifold is controlled by the temp of the water in the block.
195 to 210 degrees is NORMAL operating temperature.
. Route from inside vehicle without crimping or cutting thermal tubing then remove temoperature sending unit from engine and replace with Sun bulb assembly