answersLogoWhite

0

What else can I help you with?

Related Questions

What is the number 2 position when turning the key on a Honda accord?

Accessory position. Radio will play but ignition is still off.


How does the stop switch on a motorcycle work?

By turning the key to the off position, you are simply grounding out the ignition


How do you test controls switches on gas furnace?

by turning the control switches to the on position and attempting to light the furnace.


Does the fuel pump always run?

Electric fuel pump--Usually always when the ignition is on. Mechanical fuel pump--When the engine is turning.


Your ignition is stuck in the on position on your 94 sunbird what can you do to get it to turn back?

If the ignition in your 1994 Sunbird is stuck in the "on" position, first ensure the gear shift is in the "Park" position, as many vehicles have a safety feature preventing the key from turning. If that doesn't work, try gently wiggling the steering wheel while turning the key, as the steering lock may be engaged. If the issue persists, consider disconnecting the battery to reset the ignition system, or consult a mechanic for further assistance.


How do you set the service reminder on s40 2007?

To set the service reminder on a 2007 Volvo S40, turn the ignition key to position II (without starting the engine). Press the trip odometer reset button and hold it while turning the ignition off. After turning the ignition back to position II, continue to hold the button until the service reminder resets, usually indicated by a confirmation message or light turning off. Finally, release the button to complete the process.


Why turning my ignition on and wont turn off?

Turning my ignition on and wont turn off because it is faulty.


What causes a 1987 Mazda 323 to keep turning over in the on position when the starter and ignition switch have been replaced?

I assume that you mean the ignition OFF position. Or do you mean the starter moter keeps turning in the ON position rather than just the START position. This may be a possible wiring fault. If the wires became overheated and melted through the insualtion, the START bare wire may be touching the IGN/ON bare wire. Cheers Malcolm


How do you turn off a2000 Honda accord maint required light?

With the ignition switch in the off position, press and hold the odometer reset button while at the same time turning the ignition to the on position. After a few seconds the maintenance required light will go out.


Ignition locked up in off position and won't turn on?

Turn the steering wheel hard to the left or right while turning the key.


How do you get a Ford Expedition out of park when battery is dead?

Have you tried turning the ignition key to the run position , step on the brake pedal , and shift to neutral ?


How do you install the ignition switch in a 2004 Pontiac grand am?

The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.