router> enable
router# configure terminal
router(config) interface serial (interface number)
router(config-if) no shutdown
router(config-if) end
router#
substitute (interface number) for the actual int number.. eg serial 0/1
you can find the number of the interface by using show interfaces from privileged mode
User enable. router> enable router#
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing
HDLC
manual encryption
You can do this on the enable, or privileged, prompt.
The "enable" command will bring the privilege level from user exec to privileged exec. Example: R1> R1>enable R1#
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
show invetory y
router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.
whenever you log into your cisco router....
It's a cable used to connect from a Cisco router's DB60 serial port to a telecommunication company's equipment which provides you with a data link.
Some recommended books about Cisco routers are: Cisco Router Configuration, Cisco Routers For The Desperate, Cisco Routers for IP Router, Cisco CCNA Routing and Switching.