In many cases, the cost of the transmission medium is large compared to the cost of a single transmitter/receiver pair or a modulator/demodulator pair. If there is spare bandwidth, then the incremental cost of the transmission can be negligible. The new station pair is simply added to an unused sub channel. If there is no unused sub channel it may be possible to re divide the existing sub channels creating more sub channels with less bandwidth. If, on the other hand a new pair causes a complete new line to be added then the incremental cost if large indeed.
In analog transmission, signals are commonly multiplexed using frequency-division multiplexing (FDM)
Multiplexing techniques vary widely based on what is being multiplexed. Modern telecommunications use a very wide array of techniques including: TDM - examples: TDMA, T-carrier FDM - examples: DWDM Spatial - example: MIMO Code division - examples: CDMA Phase or polarization division - cable/satellite TV Statistcal - examples: packet mode (STS), FHSS etc etc. This is far from a complete list. I think the question needs to be more specific.
Interference is avoided under frequency division multiplexing by the use of guard bands, which are unused portions of the frequency spectrum between subchannels. by abdullahi yusuf gedi
Typically, space-division multiplexing (SDM) is realized through a set number of frequency bands. This is combined with FDM because cells neighboring those in the SDM are unable to share the same frequencies.
Approximately 14 Tera bits per second over 160 Km using wavelength division multiplexing and rising every year as multiplexing techniques develop.
In analog transmission, signals are commonly multiplexed using frequency-division multiplexing (FDM)
Frequency-division multiplexing, wavelength-division multiplexing, and time-division multiplexing.
Orthogonal frequency division multiplexing is special case of frequency division multiplexing where a ling serial data streams are divided into parallel data streams and each data stream is multiplied either by orthogonal frequency or code. when multiplied by code known as frequency code division multiplexing and when multiplied by orthogonal frequency then know as orthogonal frequency division multiplexing
Frequency-division multiplexing and wavelength-division multiplexing
Orthogonal frequency-division multiplexing
Multiplexing is the process of combining multiple signals over one media line. There are several types of multiplexing: frequency division, time division, and wavelength division.
AM radio broadcasting uses frequency division multiplexing to allocate different frequencies to different radio stations. Cable television systems use frequency division multiplexing to transmit multiple channels simultaneously over a single cable. Cell phone networks use frequency division multiplexing to separate different users' calls on the same frequency band.
Does Cable television use time-division multiplexing
Multiplexing techniques vary widely based on what is being multiplexed. Modern telecommunications use a very wide array of techniques including: TDM - examples: TDMA, T-carrier FDM - examples: DWDM Spatial - example: MIMO Code division - examples: CDMA Phase or polarization division - cable/satellite TV Statistcal - examples: packet mode (STS), FHSS etc etc. This is far from a complete list. I think the question needs to be more specific.
Frequency division multiplexing is when a communication medium divides its frequency in order to carry a number of different signals at once. Broadband DSL uses this to transport large amounts of data quickly.
http://zone.ni.com/devzone/cda/ph/p/id/269
Baseband Signalling: 1)Uses digital signalling 2)No frequency-division multiplexing 3) Bi-directional transmission 4)Signal travels over short distances Broadband Signalling: 1)Uses analog signalling 2)Unidirectional transmission 3)Frequency-division multiplexing is possible 4)Signal can travel over long distances before being attenuated