I can say with the highest confidence your temperature blend door actuator motor has failed. It is the #1 cause of heating problems on the Windstar line.
Luckily it's not too hard of a fix, and not too expensive ($45).
See "Related Questions" below for more details and lots of good tricks & tips on replacing the actuator.
The knocking on the door suddenly stops Apex 1.1.8
the system will do run for some time in knocking state and missfiress and then stops finaly...... sanaan +919997931042
owners manual say it could be normal,but carbon on pistons from my experience also cause knocking,when I remove carbon knocking stops,I have corolla with 1nze engine.
Sounds like your lifters are bad and might need ajusted or changed, it could be your cam not looping.
To reset the anti-theft system on a Ford Windstar, first ensure that the vehicle is in the "Off" position. Insert the key into the ignition and turn it to the "On" position without starting the engine. Wait for about 10 minutes until the anti-theft light stops flashing, then turn the key to the "Off" position and attempt to start the vehicle. If the system does not reset, consult the owner's manual or a professional for further assistance.
In "The Monkey's Paw," the knocking stops suddenly as Herbert, who had died earlier, is revealed to be the source of the sound. The tension builds as Mr. White realizes that the knocking is not just a figment of their imagination but a horrifying consequence of using the cursed paw. The abrupt cessation of the knocking signifies the culmination of the family's dread and the tragic consequences of their wish, highlighting the story's themes of fate and the dangers of tampering with destiny.
To reset the anti-theft system on a 2001 Ford Windstar, first ensure that the vehicle is in the "Off" position. Then, turn the ignition to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the anti-theft light stops blinking and stays on. Finally, turn the ignition back to the "Off" position, and then start the vehicle to complete the reset.
"knocking" is very broad so just a wild guess here. I think the reason the knocking stops when you disconnect the number 6 injector is; you are creating a "floating piston". In other words, this piston and cylinder are no longer producing power, they are no longer under a load, and they are no longer compressing the fuel that you have prevented from being injected into the cylinder. So, if you have something wrong with that cylinder, such as a bad piston, piston pin, connecting rod, rod bearing, etc., you have relieved the pressure which will quiet the knock. Again, just a wild guess!
When the system is at balance or at equalibrium, diffusion stops..
A knocking sound while your car is moving is probably coming from the engine. A certified mechanic will be able to perform diagnostic testing.
we will die
it stops them dying -_-