yes
Auto or stick?
The 1998 Nissan Frontier pickup truck turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be above the brake pedal.
May be the switch became defective. The solution is to replace it.
The Nissan Frontier six-cylinder fuel pump relay switch can be found attached to the frame, near the fuel tank. The fuel pump relay switch will be on the right hand side of the vehicle.
Check brake light switch - could be defective or not aligned properly
The low pressure switch will do that when the system is low on freon.
To the left of the steering wheel on the dash is a switch that says cab light. Near that will be either a blank filler piece or if your Frontier is equiped with fog lights the fog light switch will be there.
To install a stoplight switch on a Nissan Frontier, first, disconnect the negative battery terminal for safety. Locate the stoplight switch, usually found above the brake pedal, and remove the old switch by detaching the wiring harness and unscrewing it from its mounting position. Install the new switch by securing it in place and reconnecting the wiring harness. Finally, reconnect the battery terminal and test the brake lights to ensure proper functionality.
My husband is a mechanic for a Nissan dealership. He said that you would take the old one off of the transmission and replace it with a new one.
On a 1999 Nissan Frontier, the neutral safety switch is typically located on the transmission. It is mounted on the side of the transmission housing, near the gear selector linkage. This switch prevents the engine from starting unless the vehicle is in either the "Park" or "Neutral" position. If you're having trouble locating it, consulting the vehicle's service manual can provide specific details.
To replace the ignition switch in a 2001 Nissan Frontier, start by disconnecting the negative battery terminal to ensure safety. Remove the steering column covers by unscrewing the screws and gently prying them apart. Next, locate the ignition switch, detach the wiring harness, and unbolt the switch from its position. Install the new ignition switch by reversing the steps, reconnect the wiring, and reassemble the steering column covers before reconnecting the battery.
I just had this problem on my 98 Frontier because the brake lights were staying on. I had to replace the brake light switch and the brake light button for it to go out.