Dc power makes a bracket
On the Bracket for sure
Probably easiest to pull the driveaxel and take the alternator out that way
Disconnect the battery.Remove the serpentine belt.Take off the wires on the back of the alternator.Unbolt the alternator from the engine bracket.
Start replacing the 2000 s10 alternator by disconnecting the battery. Remove the air inlet hose, and the serpentine belt. Take off the bracket over the alternator if it has one. Unbolt the alternator and disconnect the wires. Reverse the procedure to install the new alternator.
you probably wont believe this, but the alternator bracket actually has coolant running through it. they leak pretty often. there is plastic pipes running to the bracket and the plastic corrodes. honest.
You need to remove the ac compressor, alternator, and their mounting bracket.
Disconnect the battery. Remove the air inlet tube. On some s10s, there is a bracket above the alternator that needs to be removed. Take off the serpentine belt. Remove the alternator wiring, then the bolts. Remove the alternator and install the new one.
To remove the alternator from a 2000 Kia Sephia, start by disconnecting the negative battery cable to prevent electrical shock. Then, remove the serpentine belt by releasing tension on the tensioner pulley. Disconnect the electrical connectors and remove the mounting bolts securing the alternator to the engine. Finally, carefully lift the alternator out of its bracket and set it aside.
Remove Air Cleaner Box Assembly to gain access to alternator, Loosen bolts on alternator mounting bracket to relax alternator, Push alternator towards block to relax belt and away from block to tighten. Now tighten alternator bolts while keeping tension on alternator.
could be a bad plug
Check for fuel and spark.