A current transformer is just a transformer designed to dutifully give an output related to turns ratio 1:xx.
the person would probably be crushed inside the transformer
A clamp-on ammeter does not measure current by capacitance. It forms a current transformer that operates by inductance. The clamp-on part is the magnetic core of the transformer. There is another winding inside that is coupled by the core to the line that is being measured. This second winding is shorted and the device reads the current through that winding. The current is proportional to turns ratio.
The container the transformer core and windings are placed inside is the tank.
2
The predominate liquid used inside a filament transformer is mercury. Mercury is used to keep the transformer cool when under heavy use. Mercury is a cheap and long lasting liquid.
REF, or restricted earth fault protection is normally applied to transformers. The idea is to set a very sensitive overcurrent on the neutral of a Wye winding. For ground faults, current will flow up the neutral, triggering this overcurrent relay to operate very quickly. To prevent this relay from tripping for faults outside "the protected zone" (such as out on a line near the transformer), information is gathered from the high, low, and sometimes tertiary windings of the transformer to determine if the fault is inside the current transformers used to gather information for protecting the transformer (can be in the transformer bushings, but is often in the breakers that operate to protect the transformer) or outside them. If inside, the overcurrent is allowed to operate. If outside, the overcurrent is restrained from operating.
A diragram that shows the inside and outside of an object.
dry cell-is a sealed container with moist chemeals inside which do not spill when carride-it is easy to get and aconinient to use-produce direct current (d.c
The BDV value of the transformer oil should be above 50kv winding resistance value should me minimum depends upon the KVA Of trans earthing should be provide for the trans air should be release inside of the tranformer insulation level should be check to operate the transformer these are all the initial condition to operate the trans
the INside
The 1999 Pathfinder fuse box diagram can be found on the inside cover of the fuse box. The diagram can also be found in the owners manual.
There is usually a wiring diagram/schematic on the inside of the blower/fan door.