To find a manual on line you will need the type, model and voltage. Look on the unit to find all of the information that you can and then do a search for it.
Yes, you can you use compact fluorescent bulbs in a garage door opener's lamp holder.
IF MY GARAGE DOOR REMOTE IS NOT WORKING AS WELL AS IT ONCE DID, IS THERE A BATTERY IN IT THAT NEEDS TO BE REPLACE??
If you have an EX model, it has 3 buttons on the overhead console. That is the Homelink Wireless Control System. Information is available in the Driving Tips Section of the Manual. (Mine is a 2004 Sedona EX) At the end of section 5 are the directions for programing the on-board Homelink Wireless Control System. There are a couple different senerios for different type of garage door openers. Hopefully This helps!
It seems likely that you have programmed the opener to continue closing beyond the point when the door was closed. When it hits the ground, and the motors feel resistance, the device is programmed to reverse the direction of the door for safety reasons (e.g. if a person is trapped under the door) There is probably a setting that will dictate how far the garage should close before it stops. There should be a sensitivity adjustment located on the opener, depending on the model, which can be moved to a higher or lower position. Check the manual, or search for the manufacturers operating manual on-line for specific instructions on how to adjust.
Yes it can. it is only a switch.
A copy of the manual for a Stanley garage door opener can be found on various websites on line. The suppliers should be able to help with a manual too.
Look in your manual
The owners manual will tell you how to do it.
no
form_title= Garage Door Opener Parts form_header= Problems with your door opener? Purchase parts. What brand of door opener do you own?*= _ [50] How old is the opener?*= _ [50] When was the garage last serviced?*= _ [50]
The owners manual tells how to program the garage door buttons good luck Cliff
To program the Challenger garage door opener, simply follow the instructions in the manual. If you do not have the manual, all you need to do is press one of the three buttons on the remote control until the infrared light turns on. This will let you know which button is compatible with your garage door opener. Once the light turns on, press and hold the button for 10 seconds to validate and secure the code.
This information is listed in your owner's manual.
read your manual.
How do you un program garage door opener
Press the button that will be used for the door opener until the light starts flashing. Then hold up your garage door opener remote and press to open garage door. It will then set.
program garage door opener for honda ridgeline