0
What else can I help you with?
What are the rocker cover torque settings of a fiat punto?
8-10Nm
What is the torque setting for the valve cover on a TD5 land rover?
TD5 Engine rocker torque setting is 10Nm or 7lbft
What are the torque specifications for 89 s-10 rocker arm stud?
For the 1989 Chevy S-10 with the 2.5 liter engine, the torque setting for the rocker arm bolt is 22 ft. lbs. The torque setting for the rocker arm cover is 75-inch lbs.
What are the torque settings for the rocker cover on a 1993 mx6 2.5 v6?
43 - 78 inch lbs.
How can a rocker arm on a 1990 Geo Tracker be replaced?
By removing the valve cover from the engine, then removing the rocker nut on the bad rocker. Refer to a technical manual for torque specifications, as this must be properly torqued!!!
What are the torque specs for a n14 cummins?
The torque specifications for a N14 Cummins engine typically vary based on the specific part being tightened. It is important to refer to the manufacturer's manual for the most accurate and up-to-date torque specifications for each component.
What is the torque spec for a rear differential cover on a 2000 ford ranger?
the recommendation for the differential housing cover bolts is 16 ft. lbs.
On a 1996 Hyundai accent where can you find out if it is a single overhead camSOHC or a double overhead camDOHC?
Usually the width of the rocker cover. If it if fairly narrow its usually single, a wide rocker cover is usually housing 2 cams . Answer Does the valve cover say 12V or 16V the 12V is a SOHC and the 16V is a DOHC
How much torque does a dodge diesel have?
depends on the year, auto or manual, High output or not. on your dodge cummins, the front cover on your engine will have a tag with the HP and ft lbs of torque on it. It will be on the drivers side on the edge of the cover. You might want to take a rag with you to wipe it off.
What is series 60 Detroit diesel rocker cover bolt torque specification?
The torque specification for the rocker cover bolts on a Series 60 Detroit Diesel engine is typically around 18-22 ft-lbs (24-30 Nm). It's important to follow the specific torque sequence and procedure outlined in the service manual for the engine to ensure proper sealing and avoid damage. Always double-check with the latest manufacturer guidelines or service literature for any updates or specific variations.
What is the valve cover torque specification for a Dodge Ram?
the chiltons manual for my 1990 B150 dodge ram van states 80 inch pounds. For a Ram 2500 with 5.9L Cummins 12 valve engine. The torque should be 18ft-lbs or 24Nm.
How do you know the size of the rocker arm stud on your car?
Remove a rocker cover and measure one.
