0
What else can I help you with?
What is the valve cover torque specification for a 1995 Dodge Dakota 3.9?
95 in-lbs.
What is torque spec for 2001 altima valve cover?
The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
What are the valve cover torque specs for a 2001 3.0 Mitsubishi Montero Sport?
The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.
What is torque specification for 2002 ford 3.0 dohc valve cover?
I was told 7lbs
What is the valve cover torque on a 2000 Mazda Protege 1.8L?
The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
What is the valve cover torque specification for a Jeep CJ7 1985?
6-8 lb/ft.
What is correct torque for 1991 dodge Dakota valve cover?
If you are asking because of your valve cover leaking oil, there was a recall on that year valve cover gasket.
What is the valve cover torque for the 5.9 dodge?
95 ft inches of torque , make sure it is in ft inches of torque and not ft lbs.
What is the torque spec for 1999 Dodge Ram Magnum 318 valve cover?
The torque specification for the valve cover bolts on a 1999 Dodge Ram with a Magnum 318 engine is typically around 7-9 ft-lbs (or 84-108 in-lbs). It's important to tighten the bolts in a crisscross pattern to ensure even distribution of pressure. Always refer to the vehicle's service manual for the most accurate and specific information.
How do you torque a valve cover on a Toyota Previa?
To torque a valve cover on a Toyota Previa, first ensure that the engine is cool and the valve cover is clean. Use a torque wrench to tighten the valve cover bolts in a crisscross pattern to ensure even pressure. The recommended torque specification is typically around 7.2 to 9.0 ft-lbs (10 to 12 Nm), but it's best to consult the specific service manual for the exact specifications. Always double-check the torque after the initial tightening to ensure proper sealing.
What is the valve cover torque specification for a suzuki side kick?
I think there is no torque required for the valve cover as long as all are evenly tightened or the seal is flat on the cylinder head it will not cause any leak. If you have tightened the valve cover screws already and there are still leaks you might want to consider putting silicone on the valve cover gasket before you attach it or you might want to consider buying a new valve cover gasket.
What is the valve cover torque requirements 98 Nissan frontier 2.4?
valve cover torque 98 nissan2.4
