If certain plastics (take for instance PTFE) is subjected to stresses below its yield point then it may be subjected to permanent deformation. This deformation will induce certain strains through out the material. If the plastic is heated up, these strains tend to relax which allows the plastic to return to its original shape. This is often refered to as "plastic memory".
Anelastic deformation. Deformation processes where a material assumes its original shape after the load is removed, but with a time delay.
Deformation is calculated by using deflecto meter.
Deformation is a change in the shape and volume of a rock, deformation is produced when a rock experiences a stress that is greater than the strength of the rock.
It may speed up when heated.
deformation
When the barbique hot plates are heated or coolede down, due to the change in temperature there will be a minor deformation of the material. During this small deformation, the sounds occur.
Brass and Iron
1. Deformation 2. Melting 3. Possible "explosion", depending on the content
If certain plastics (take for instance PTFE) is subjected to stresses below its yield point then it may be subjected to permanent deformation. This deformation will induce certain strains through out the material. If the plastic is heated up, these strains tend to relax which allows the plastic to return to its original shape. This is often refered to as "plastic memory".
elastic deformation
John Harrison
elastic deformation, ductile deformation and fracture
The bimetal mechanical thermometer uses one end of a bimetallic coil connected to the housing of the device and the other end drives an indicating needle. The bimetal mechanical thermometer is often used in things like refrigerators, air conditioners and heat control.
Elastic deformation is recoverable deformation. As such, when the load that caused the deformation is removed the material will return to it's original shape.
it will take long to be heated up,
ductile deformation