If the train is going at a constant speed, it will make no difference whether she runs forward or backward. There will only be a difference if it is accelerating or slowing down. If it is accelerating you tend to be thrown backward, so it is easier to run back than forward. If it is braking you are thrown forward so it is easier to run forward than backward. The force on the body is the product of the acceleration or retardation and the mass of the body: F (Newtons) = mass (kg) x acceleration (meters/sec2)
its near the driver fender towards the front of the hood has 3 circuits running into it.
no that is anterior, superior is towards the top head, inferior is towards the bottom
need to replace my front lower running / blinker bulb how do i do it
no
Towards the back is posterior and towards the front is the anterior.
If you are in front of a flat mirror, your image appears to be twice the distance from you as the mirror.In optics they use ray diagrams to demonstrate this. If you did not know the mirror was there, the image would be 4 meters from you, two meters behind the mirror.
index towards magnetic field, middle towards current, and thumb towards the force - all 3 fingers should be perpendicular to other 2.......point your middle finger towards your front, thumb upwards and middle finger to the right, that is the rule.
There are 2 clips about 12 inches in from each side - the trick is to push down real hard on the front of the seat while at the same time pushing/pulling the front of the seat forward (towards the front of the car).Do one side at a time.Once the front of the seat bottom is free, just tilt it up and towards the front.Lay down and force the bottom of the seat backwards and slightly upwards with your arms or shoulders to force the seat from the retainers on two sides. When the front comes up - you can remove the seat.Get in to the back of the car and push very hard on the seat cushion towards the trunk. While you are pushing hard, lift up on it and the cushion should pop out. From there, there will be two bolts holding the rear part of the seat in.
1st move the light switch to the desired position. 2nd PULL the switch gentle towards you. There are two positions for this switch. The first position or click, will turn on your front running lights. The second position or click will turn on both your front running lights and additional lights in the rear. You will be able to tell that you have activated them by the icons on your dash that will inform you they are on. To turn off simply push the switch back in. (Actually, those are the FOG lights, front and rear.)
For the Mk2: - place a flat-head screw driver in-between the reflector and sidelight. Then lever out the sidelight towards the front of the car. The plastic is quite bendy but don't use too much force, and the unit will pop out.
caca
Anterior. Meaning towards the front.