The density of water is 1.0
Yes. Cold water is slightly heavier than hot water. (That's why stoves are built to heat the bottom of the pot, not the top.)
It doesn't, coffee is grown. The way a percolator works is by the change in the density of water when it is heated. Water is placed in the percolator then the riser tube is placed in and the filter cup with ground coffee in it is placed on the top of the tube, ABOVE the top surface of the water. The water is heated at the bottom of the pot, this hot water rises and is directed up the tube, cold water replaces it at the bottom of the pot, this cold water as the density is much higher forces the hot water up the tube where it overflows into the filter basket and percolates back down through the coffee grounds, then back to the pot to be cycled through again. The percolation slows down as the temperatures in the pot equalize, or the water level is lowered.
Radiation and conduction have nothing to do with it. Convection causes the water at the bottom of the pot to heat up, lowering its density and sending it to the top of the pot. It then cools, increasing its density and sending to the bottom of the pot. Repeat.
Density
Density
warm water pot is the Dutch translation. This is the translation of hot water pot.
They can float in hot. Like if you boil eggs, before you set the pot, water, and eggs on the stove, you see that they don't float until the water gets warm.
Yes, it does. The reason is that there is a larger surface area for the large pot of water than the small pot of water -*-*princeszbitez*-*-
An object will float - on water for example - if its density is less than the density of water. Density = mass / volume.An object will float - on water for example - if its density is less than the density of water. Density = mass / volume.An object will float - on water for example - if its density is less than the density of water. Density = mass / volume.An object will float - on water for example - if its density is less than the density of water. Density = mass / volume.
This is the determination of the specific density (the ratio liquid density/water density).
An effective potholder has density and low conductivity.
Earthen pot has tiny pores on its surface. The water oozes out from these pores. It then evaporates taking energy known as "latent heat" from the pot. Thus, the temperature of the water inside decreases. This process goes on and this is the reason why the water in earthen pot is cooled faster.