0
Describe How microprocessor uses data from the temperature sensor?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What sends data to a microprocessor in a washing machine?
This will depend entirely on the program that was written to tell the microprocessor what to do to convert sensor readings to control actions. There are a nearly infinite number of different way to do this. Some things you might wish to look into are: control system theory, z-transforms, fuzzy logic, etc.
What is temperature sensor?
data logger pt 100 sensor
What weather data does the Temperature sensor record and how does it do it?
A temperature sensor records temperature through the means of a mercury thermometer.
What is pt100 temperature sensor?
data logger pt 100 sensor
The system component that controls and manipulates data in order to produce information is called the?
microprocessor
Does a microprocessor hold data in the interpreter register?
No.
Why is data bus bidirectional but address bus is unidirectional?
since data can be read /write from/to the microprocessor, hence data bus is bidirectional. if data is required read from microprocessor then it will be pointing to a memory location by the address bus, by indicating which location data its required to read. similarly to write a data to a location, again the microprocessor will be to that particular location by holding that address in address bus. hence it will be unidirectional.
What is known as 8 bit internal bus?
the bus through which the data are transmitted or received within microprocessor and with peripherals is called as data bus.when used internally to microprocessor called internal data bus.
How does a microprocessor know whether the next byte is an instruction or data?
A microprocessor know whether the next byte is an instruction or data because the microprocessor knows for what it is looking. The bus, on the other hand, for an 8085 based system, knows an opcode from data by looking at S0 and S1 when IO/M- is low. If both are high, it is an opcode, otherwise it is data.
What is the data path beween the microprocessor RAM and the peripherals?
Data bus
What is HL pair in 8085 microprocessor?
HL is a register pair used to store 16 bit of data in 8085 microprocessor.
Where is Jeep Grand Cherokee Laredo outside temperature sensor. Temp always reads 0C. will sensor replacement fix this?
The Ambient air temperature is monitored by the Electronic Vehicle Information Center (EVIC) through ambient temperature messages received from the Body Control Module (BCM) over the Programmable Communications Interface (PCI) data bus network. The BCM receives a hard wired input from the ambient temperature sensor. The ambient temperature sensor is a variable resistor mounted to a bracket that is secured with a screw to the right side of the headlamp mounting module grille opening, behind the radiator grille and in front of the engine compartment. The ambient temperature sensor cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.OPERATIONThe ambient temperature sensor is a variable resistor that operates on a five-volt reference signal sent to it by the BCM. The resistance in the sensor changes as temperature changes, changing the temperature sensor signal circuit voltage to the BCM. Based upon the resistance in the sensor, the BCM senses a specific voltage on the temperature sensor signal circuit, which it is programmed to correspond to a specific temperature. The BCM then sends the proper ambient temperature messages to the EVIC over the PCI data bus.The temperature function is supported by the ambient temperature sensor, a wiring circuit, the Body Control Module (BCM), the Programmable Communications Interface (PCI) data bus, and a portion of the Electronic Vehicle Information Center (EVIC) module. If any portion of the ambient temperature sensor circuit fails, the BCM will self-diagnose the circuit. A temperature reading of 130° F will appear in the EVIC display in place of the temperature when the sensor circuit is shorted. A temperature reading of -40° F will appear in the EVIC display in place of the temperature when the sensor circuit is open.
