Want this question answered?
The power steering can not be adjusted on a Massey Ferguson 165 tractor. Check to make sure the hydraulic reservoir is full. This is usually the cause of most steering issues.
It appears that Massey Ferguson built the first ones in 1947. It was the Massey Ferguson TO-20 Toy Pedal tractor. From here, some of the tractor builders would make pedal tractors after the big motorized models. John Deere made their first in 1968.
Using an educated guess I'd say Massey Ferguson.
There is no best make of tractor. What works best in one country may not be so efficient elsewhere. That is why there are so many. But in the US Massey Ferguson, John Deere and Fendt are the most popular and considered the best.
5 foot X 6 foot
Loader on Massey 1010 tractorThere is a site http://www.loaderplans.com that offers plans for loaders to fit small tractors of all types. The Massey 1010 is similar to Allis and Deutz-Allis models made by Hinomoto, for which the manufacturer and loader manufacturers make models to fit. It should be noted that hydrostatic transmissions are better able to withstand the strain of heavy use such as loader work than gear transmissions. On any tractor the side rails (frame) should be reinforced with plate steel and the side brackets should be fastened to a cross beam under the tractor to prevent stress damage from the loader.
Somewhere between 1,500 pounds and 100,000 pounds, depending on the make and model of tractor, and on the accessory equipment it might have.
AYP, who make Husqvarna equipment, made the Craftsman 917.28990 (a sweet unit if you can get a good price).
What's the make (manufacturer) and model? That information will be pertinent before this question can be answered.
Typically, 11 to 16 liters displacement, depending on exact make and model of engine.
It depends on the make of the tractor. Modern tractors are usually started by the turning of an ignition key - as with a car. I once drove an old Ferguson tractor that had a brass button that had to be pushed in with my heel, while moving the gear lever into a slot marked start. Unless the brass button was pushed in, the gear lever couldn't enter the start slot!
you look at what model it is and look up when the model was made. If you could give more details maybe I could help better.