I just got off the phone with Splash Lagoon and was told the Wave Pool won't open until sometime next year (2011).
Visit www.splashlagoon.com/wavepool to see updates on the wavepool construction!
Yes there is, and they are also producing a lazy river that is almost done.
1.Which does not add new alleles to a population gene pool?
You add water to the pool
H2O: Just Add Water & Blue Lagoon
Add alot of iodine
boast
Make sure your pump is running 15 minutes before adding liquid acid to your pool. This will insure that there are no areas in the pool with water that is not moving and circulating. Now get a bucket a fill it with pool water 2/3 full. Now add the acid to the bucket. Next you will be pouring the contents of the bucket into your pool. Make sure not to splash any on you (ouch) or on your decking. In either case wash off immediately with fresh water. To add to pool; pour contents of bucket as you walk around the deep end trying not to pour right down the walls of the pool. Next rinse your bucket in the shallow end and use your test kit in an hour or two (depends on circulation capacity) to detemine whether or not you need to add more liquid acid. Note: It is better to add small amounts more often than to add huge amounts all at once!
You add D.E. to a pool when you do a fresh filter clean. You also add D.E. if you have to backwash your pool more than normal. When you backwash the pool it is also dumping the D.E. out so it needs to be replaced to keep the grids covered so the pool can filter properly. Hope it helped
Yes you can add shock solution to your swimming pool after or at the same time as a clarifyer. You should not swim in your pool for at 4 hours after shocking it.
They add up.
To raise the pH of your pool you add soda ash (sodium carbonate). To lower the pH of your pool add muriatic acid (hydrochloric acid) or sodium bisulfate. You should always add chemicals with the pump running and check your levels again once the newly added chemicals have been circulated around the pool.
Add salt