0
Did the klze motor from japan ever come with a LSD transmission?
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Did a 1984 thought 1987 Monte Carlo ever come with a manual transmission?
No
When does the movie Naruto 6 come out?
early 2011 in America late 2010 in japan if it ever is made
Where is the transmission oil filter on a 1999 Hyundai Elantra?
The transmission oil filter is in the transmission drip pan under the driver's side close to the front tire. there is no transmission filter. there is how ever a oil filter which is located on your bottom right or possibily left side of your motor. the transmission however holds trans mission fluid which can be drained!
Did the movie Dragon Ball Yo Son Goku and His Friends Return ever come out in America?
No only in japan.
How do you replace 1978 Chevy flywheel?
You have to remove the transmission or remove the engine, one or the other has to come out, which ever is easier, it depends on the the vehicle.
Did a Nissan 240sx ever come carburated?
Nope. 240s only have a single and a dual cam motor both are fuel injected.
How to find the best manufacturer for mechanical transmission and hydraulic transmission?
Hangzhou Ever-Power Transmission Co., Ltd. Ever-Power (Shaoxing) Co., Ltd.
Does trans. have to be lowered to Replace rear main seal 88 Chevy s10?
The engine or transmission has to come out, one or the other, which ever is easier.
When you should change car manual transmission fluid?
When the fluid no longer look red. Transmission fluid normally doesn't have to be changed that often. For a manual transmission, maybe after 100K. The manual transmission fluid is thicker and hardly ever breaks down. Unless the gears are clashing, etc. But for an automatic transmission: that would depend on how you drive you vehicle. A good idea for a transmission fluid change would be every 3rd to 4th motor oil change. The transmission fluid is completely different from motor oil, but will eventually wear out. I say a fluid and filter change. It is usually a bad idea to get a transmission flush if the transmission is doing good, so far.
Does a pulley that goes around a motor come off?
That depends on how the pulley is mounted on the motor. If the pulley is welded then no most likely you will have to cut it to get it off. However, if the pulley is fixed to the motor using a bolt/s or other fasteners then yes. Warning: The pulley could be press fit onto the motor. If this is the case it can come off but might not be able to ever go back on.
Have Japan ever had a twister?
Yes. Japan does occasionally get tornadoes.
Is there a Rooney sewing machine ever made?
Yes i have one,It is a great sewing machine with a strong motor.The one i have is a portable,and it is great.The machine is made in Japan and the motor is made in the USA.
