Load balance is a high-availability (HA) scheme, where the service calls direct to one of many service providers, in this case a Message Queue manager, such that it is likely that one is available and ready for access. Fault-tolerance (FT) is about what happens when one of the MQ managers dies unexpectedly, and does it lose the messages that were enqueued there. In my experience, FT with MQ is harder to do, and requires duplication of the MQ manager state in some fashion.
there is no difference
tell me
tell me
There is a difference between: Worksheet and Balance Sheet
There is a difference between: Worksheet and Balance Sheet
WAS 6.0 runs on JRE 1.4 WAS 6.1 runs on JRE 5
the difference between the two is the zone of tolerance
what is the difference between balance n product modulator
speelling
Tolerance refers to the acceptance or open-mindedness towards different beliefs, opinions, or behaviors. Tolerating, on the other hand, is the act of enduring or putting up with something that is unpleasant or undesirable. In essence, tolerance is more about embracing diversity, while tolerating is more about enduring discomfort.
Tolerance is unintended deviance from basic size, while Allowance is intended.
In engineering, general tolerance refers to the overall tolerance. A specific tolerance would be noted on a blueprint when an area requires a tolerance which is different than the overall project.