0
The difference between a timer and a counter is that a timer can be set to record different time intervals. As were a counter only records an overall length of time.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is the difference between timer and counter?
A counter counts up, a timer couts down.
What is the difference between the DN and EN outputs of a timer or counter in a PLC?
PLC differences between timer and counter
What is the difference between on delay timer and off delay timer?
The difference is that one is on and the other is off.
What is difference between timers and counters?
Stupid question the diffrance is that a timer is small a counter is big timers are used for time counters are used like desk did is answer it
Difference between 555 ic timer and 556 ic timer?
556 is a dual version of 555 single timer.
What is the difference between a timer chain and a timer belt?
chain in inside the engine and the belt is outside
What is the difference between a timer and an hourglass?
The hour glass has a predetermined time.
Is the 555 IC an up down counter?
The 555 is a timer, not a counter.
What is the difference between a cross offer and counter offer?
the difference between offer and counteroffer
What is difference between decade counter and binary counter?
a counter is a counter which counts the data and the decade counter is the counts the decade ones
What is the difference between timer and counter in microcontrollers?
timer uses internal clock frequency, and generates delay counter uses external signal to count pulses... Timer *the register incremented for every machine cycle. *maximum count rate is 1/12 of oscillator frequency. Counter *The register is incremented in response to a 1- to -0 transition at its corresponding to external input pin(T0,T1). *maximum count rate is 1/24 of oscillator frequency. *External I/P signal must be kept at least for one machine cycle
What is the difference between AC timer and DC timer?
It would be more good if a contrast has been inquired between a timer or a counter, but although it is a question and question is to be answered, I will try to point out difference b/w ac and dc timer. if a comparison has been made b/w ac and dc signals, then it would come to us that they both are two different means to achieve the same objective. Both are used to behave as a source of energy which is essentially desired to drive an electrical load, They both are transformable, An ac signal can be converted to dc using rectifiers or an ac signal of the desired frequency can be generated using oscillators that would be further amplified up till the required strength, In this case dc signal is provided to biased the semi conductors that was involved in both ac and dc signal. As far as the difference b/w ac and dc timer is concern in both case timer behave as a device that generate interrupt after counting certain value, It can count both up and down. To illustrate difference b/w counter and timer it should be made very clear that to count up and down depends upon an occurring of an even in case of counter where as for timer, Any event is not desired to count up or down, Counting has been made periodically. In most cases timer are digital in nature, involved sequential circuit and controlled by micro controller or processor where the logic has been defined. Usually it is seen that timers and both counters are embedded in the controllers. I never heard of ac counter, if there would be any then it can be considered as a device where a conventional pure digital counter is followed by a rectifier that provide the required dc levels to biased semiconductor device involved in the construction of Timer.
