Step up Transformers increase the voltage, while step down transformers reduce it. Higher voltages are better for electricity transmission/distribution, because, for any given load, the higher the voltage, the lower the resulting current. This means the supply conductors can have a lower cross-sectional area and the resulting saving in copper makes the installation cheaper. A lower load current also means lower line (energy) losses.
Rectifiers turn A/C into D/C, but transformers can only run on A/C.
the maximum power it will supply
Stepdown Transformer.
It depends on the type of transformer:transmission/distribution transformers step up or step down system voltagesisolation transformers electrically isolate two systems without affecting their voltagesmatching transformers are used in electronic circuits for impedance matchinginstrument transformers step down voltages (voltage transformers) or currents (current transformers) for measurement or protection applications
A variety of electrical transformers are produced for a variety of purposes. All of the types use the same principle discovered by Michael Faraday, and employ many of the same parts. The various types include. Audio transformers, Instrument transformers, Pulse transformers, Power transformers, RF transformers. .
Transformers are necessary to stepup or stepdown voltage levels so that transmission of power is convenient. without stepup/stepdown voltage level according to our requirement losses will be very high and transmission and usage of power is not feasible.
step up and stepdown
Transformer is the only device which is capable to stepup or stepdown an ac signal. That's why its used widely in ac supply.
Rectifiers turn A/C into D/C, but transformers can only run on A/C.
the potion ludacris
the maximum power it will supply
Stepdown Transformer.
It's a transformer that operates with AC current in and out. It's an ordinary transformer, with the term "static" used to differentiate it from rotating transformers, such as motor-generator sets.
step up or stepdown is done by the ratio of the number of turns in the primary / secondary coil, large number on high voltage side small number on low voltage side. the wire used on the low voltage side would be thicker than the high.
If you have to pay for the stepdown transformer, yes. If that is provided free, there is a small loss of energy in the transformer, maybe about 5%, and it depends on whether the meter is installed before or after the transformer.
The way to identify any transformer is to look at the the transformers nameplate. The primary side will be designated H1 to H4. This is the primary side and the voltage will be stated as to the voltage to connect to. The secondary side will be designated X1 to X4. This is the secondary side and the voltage will be stated as to the voltage it will be transformer to.
Jones chopper is known as voltage commutated chopper...it is one type of chopper..