I am assuming that windows would usual restart on a particular instance, but with this option windows will not restart if a problematic occurs on the system. Maybe such as a blue screen of death. Safe thing to do is use this feature if have know some common issues with your system.
Disable automatic restart on system failure
disable automatic restart on system failure
Disable automatic restart on system failure. Compared in Figure 14-8 and Figure 14-9 in A+ Guide to Managing and Maintaining Your PC Sixth Edition on page 699.
Blank screen: windows lose activation Other: press f8 and disable automatic restart on hardware failure
Fail-passive Automatic Landing System An automatic landing system is fail-passive if, in the event of a failure, there is no significant out-of-trim condition or deviation of flight path or attitude - but the landing is not completed automatically. NOTE: For a fail-passive automatic landing system the pilot assumes control of the aircraft after a failure. The following are typical arrangements: (1) A monitored automatic pilot in which automatic monitors will provide the necessary failure detection and protection. (2) Two automatic pilots with automatic comparison to provide the necessary failure detection and protection. Fail-operational Automatic Landing System. An automatic landing system is fail-operational if, in the event of a failure, the approach, flare and landing can be completed by the remaining part of the automatic system. NOTE: In the event of a failure, the automatic landing system will operate as a fail-passive system. The following are typical arrangements: (1) Two monitored automatic pilots, one remaining operative after a failure. (2) Three automatic pilots, two remaining operative (to permit comparison and provide necessary failure detection and protection) after a failure.
depends is it standard or automatic
bell end failure
The light can not be disabled. If it stays on, there is a failure in the system that will have to be repaired.
Yes. From low fluid, plugged filter, or an internal failure.
DG Controller is a 3-phase Automatic Generator Controller module that includes protection for GENSETS. Use of advanced micro controller in the design platform provides easy and trouble free control and operation mechanism of GENSETS in case of failure of mains power.
Blend door actuator failure.
There is an internal clutch failure.