1. Car off, all belts unbuckled, parking brake on
2. Turn key to on position. you will see seat belt warning light light up red
3. After 1 min you must buckle and then unbuckle seat belt you want to disable warning for 9 times exactly and finish doing this within 50 seconds of the light going off
4. Airbag light will go on for 3 seconds or so
5. After it goes off, buckle then unbuckle seat belt again 1 time
6. Light will flash, seat belt warning disabled.
plug the seatbelt in.. the warning stops then ;-)
You can disable the seatbelt warning chime, in your Honda CRV, by removing the fuse. The fuse can be found in the fuse box in the engine compartment.
To disable the seatbelt chime in a 2011 Kia Optima, buckle the driver's seatbelt and turn the ignition to the "On" position without starting the engine. Wait for the seatbelt warning light to turn off, then unbuckle and re-buckle the seatbelt three times within 30 seconds. Finally, turn the ignition off, and the chime should be disabled. If it doesn't work, you may need to consult the owner’s manual for specific instructions or check with a dealer.
To disable the seatbelt chime on a Honda Pilot, start the vehicle and ensure the driver's seatbelt is unbuckled. Turn the ignition to the "ON" position without starting the engine, then buckle and unbuckle the seatbelt three times within 10 seconds. After that, turn the ignition off. When you start the vehicle again, the seatbelt chime should be disabled.
By wearing your seat belt.
Buckle your seat belt.
To disable the seatbelt chime on a 2011 Crown Victoria, you can follow these steps: Start the vehicle and buckle the driver’s seatbelt, then turn the ignition off. After that, unbuckle the seatbelt and turn the ignition back on without starting the engine. Buckle and unbuckle the seatbelt three times, ending with it unbuckled. Finally, turn the ignition off, and the chime should be disabled.
get an old seatbelt from a junk yard and plug in into the seatbelt soquit
To disable the seatbelt chime on a Ford Taurus, first, buckle the driver's seatbelt and turn the ignition on without starting the engine. Then, unbuckle the seatbelt and buckle it three times within a span of 10 seconds. After the third buckle, you should hear a chime indicating that the feature has been disabled. Turn off the ignition to save the setting.
simply wear your seatbelt.
Put on your seatbelt!
THIS DID NOT WORK ON MY 2007 CAMRY..ANY OTHER SUGGESTIONS??