No. It lowers the compression ratio and reduces power output.
No. The 350 has bigger valves. While you CAN put the 305 heads on the 350, (I can't imagine why you would actually want to) you can NOT put the 350 heads on the 305. Because of the 305's small bore, the valves on the 350 heads will hit the cylinder block.
No. 305's have small valves due to the 305's small bore. Large valve heads can't be used on the 305 because the valves will hit the cylinder block. 350 heads breathe MUCH better than 305 heads. Stick with the 350 heads.
Yes
no
Yes, but running a 350 cam with 305 heads is not effective,you need to run 350 heads as well. In order to benefit from a 350 cam you need something to flow that extra fuel and air, so using 350 heads along side of the 350 cam will be the cheapest and best choice. HAVE FUN!! A 350 head can physically bolt onto a 305 block. However, 350 heads can have the valves extend into the cylinder and contact the cylinder wall (even with the smaller 305 cam). The 350 cam in the 305 with stock heads will work. You wont want to use 350 heads you will lose compression due to the largers combustion chambers.
Not a good idea. 350 heads will lower compression to 7 to 1 or less.
The headers for a 350 and 305 are the same.
Your question is a little vague, so im assuming you're asking which is better between 350 and 305 heads. Many people will tell you it doesnt matter. I think if you have a 350 engine then you should use 350 heads. the 305 heads will have higher compression, which will make the car louder, and somewhat faster, however, if you use 305 heads on a 350 engine then you should use a high octane fuel, so it will be better on your engine. Only use 305 heads if you know what your doing. if not you should probably stick with 350 heads. i hope that answered your question.
Not fit. Different blocks, altogether.
Not fit. Different blocks, altogether.
No. The bore size is different between a 305 and 350. The 350 bore size is larger.
Yes they will, But you will have to drill the 4 center bolt holes out in the 88 intake to make it bolt up to the 305 heads. I don't no why anyone would want to put 305 heads on a 350 engine, The 350 will never run like it did before.