A collision will never occur in full duplex.
Full Duplex Ethernet uses no network control protocal to prevent collisions. This is because full duplex has a deicated channell for transmit and receive. When communicating in full duplex mode, there is no area to have a collision.
Data collisions occur when data is transmitted on the same medium at the same time. Therefore, to avoid data collisions, connect all hosts to a full duplex switch.
With Full-Duplex cabling, time is saved as, due to elimination of collisions, frames need not be retransmitted. Also, the separation of the send and receive functions means that the full data capacity of the cable is available in both directions.
Excessive late collisions
Full Duplex
Full duplex has the highest throughput concering communication.
This is only true when both hosts are on the same collision domain and are operating at half duplex.
Yep. Full duplex is one of the two way voice communication methods.There are three types of two way voice communication such as simple duplex, half duplex and full duplex.
a full duplex system
Full-duplex or duplex
Late collisions are collisions that happen after the first 512 bits of the ethernet frame. These losses are not recovered by the network layer; it is up to the higher protocols to rerequest data if any was lost. The most common cause by far is a duplex mismatch. Check to be sure both sides of the connection agree on either half-duplex or full-duplex. Other causes include cable lengths exceeding the 100-meter standard, a inappropriately large number of hubs in the network, or faulty ethernet cards.
videoconferencing is full-duplex