There are many different kinds of fire doors and not all of them are tied to the alarm system. Some fire doors will only close when there is enough heat to sever a fusible link.
However, as a general rule, automatically closing fire doors that are latched open with electrical controls would release the latch and close the relevant fire doors upon triggering of the fire alarm by any initiating device.
close the bonnet and then lock the doors
The alarm is reset by unlocking the doors with a key or the remote.The alarm is reset by unlocking the doors with a key or the remote.
You can disarm the alarm by unlocking the doors with a key.You can disarm the alarm by unlocking the doors with a key.
The factory alarm is reset by unlocking the doors with a key or the remote.The factory alarm is reset by unlocking the doors with a key or the remote.
sit in the drivers seat and close all the doors, then arm the alarm and wait (while not moving) for approx 1min then move around and the alarm should go off
Automatic door systems and the fire alarm systems are linked together. Automatic doors are held open by strong magnetic type devices, that are activated(turned on) during normal activity. When the alarm is activated, the devices are shut off and the doors close. These doors are programmed to close in an effort to keep smoke and flames from spreading too far(these doors are usually strongly fire resistant.) Once the alarm is shut off/reset, the devices will be activated again and will remain open once somebody opens the doors back up. Another type of "automatic door" is a fire door that slams shut (springs, counterbalances, gravity, etc) when the heat-sensitive link melts, or when a fire alarm is activated. These heavy doors are NOT intended to be opened during a fire for means of escape, so there must be other doors accessible for people to escape the area safely.
The factory alarm is reset by unlocking the doors with a key or use the remote.The factory alarm is reset by unlocking the doors with a key or use the remote.
which alarm? if it the security alarm then its because all the doors are not unlocked when they are being opended and if you pop your trunk but the doors are not unlocked it will do the same.
Close all the doors then use your key, keying through the door key hole to turn lock then turn to unlock all the doors.
If it is a factory alarm then shut all the doors, and use the key to lock and unlock all the doors.
A car that has a alarm will usually have a red light on the instrument panel that when you lock the car with the key fob will come on and stay on for a few seconds. After the alarm is set the light will begin to flash. To test the alarm roll down the drivers window and close all the doors and trunk and on some cars even the hood has to be closed. Lock the doors with your key fob and when the red light starts to blink unlock the door manually by reaching inside to unlock it and open the door from the outside. The alarm should sound. To turn off the alarm use the key fob to unlock the doors.
they can close easily and they shut off the electricity when a fire alarm goes off magnets don't work any more and the they can be turned on and off.