Perhaps, or perhaps not. Your question is not specific enough.
As a general rule, each load device demands it's required service. The perhaps not may involve load devices that communicate with each other.
Any devices that are added to a circuit and need the full line voltage to operate, are added in parallel to any other load devices or fixtures in the circuit.
To close a circuit in electrical terminology is to close any open devices that are in series with a connected load. Once this happens the current will flow through the load and the load is then termed as energised. In the case of a motor circuit the motor will operate. In the case of a lighting circuit the lamps in the circuit will energise and light the area in which they are installed.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
Resistance load it means there is passive load to impede current flow. Inductive load means there is a coil as a load while still a passive it has its own characteristics which differs from a resistive load which is linear while inductive is not linear load
Watts = Volts x Current x Power Factor. Power Factor is one for resistive loads and less than one for reactive loads. If you assume 80% load factor on your 10 amp circuit that is 8 amps. So each of three devices would have to operate on 2.66 amps. To do this the applied voltage for each device would have to be 900 volts.
To make something operate independently again. To siloize (silo - ize) is to make something operate independently, like a silo.
All levels
Any devices that are added to a circuit and need the full line voltage to operate, are added in parallel to any other load devices or fixtures in the circuit.
Yes, they can.
All levels
Yes.
All levels
A dual band router will allow 802.11g devices to operate on the 2.4 GHz band while allowing 802.11n devices to operate at their maximum speed on the 5GHz band. Both the G and N devices will be able to operate simultaneously.
Assistive mobile devices are tools designed to improve the mobility and stability of persons who have difficulty moving independently.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
Shares in load funds are usually sold through separate distributorships
To close a circuit in electrical terminology is to close any open devices that are in series with a connected load. Once this happens the current will flow through the load and the load is then termed as energised. In the case of a motor circuit the motor will operate. In the case of a lighting circuit the lamps in the circuit will energise and light the area in which they are installed.