Yes, but not sure if the parts are interchangeable.
Your Blower resistor is located on your firewall under the hood. It is located on the same side as your glove box, just not immediately behind it. it is right beside your blower motor. You also have to cut away the factory rubber covering on the part. I just used an ordinary knife. After that all you need to do is unscrew the old resistor and replace. It's pretty basic when you know where it is. Hopefully you haven't taken your dash apart yet.
resistor is to resists the flow of current
series controller, shunt controller,series-shunt controller,series-series controller
The most Basic or Simple electronic component is the resistor capacitor.
a battery and a resistor connected together.
I suppose you mean the blower motor for the inside heat and air conditioning. You will need a voltmeter to perform this test and some understanding of basic electrical circuit function. I cover this test in detail in my upcoming book Automotive Driveablity: A Guide to Engine Performance Testing. Locate the connector to the blower motor. Turn the fan on high speed and measure the voltage at both wires...one should be system voltage (about 12v with the key on, engine off) and one should be near 0v...that one's the ground side, and the one that runs through the resistor pack at lower speeds. With the voltmeter still measuring voltage at the ground wire, move the selector down through the different speeds. Your reading will gradually increase, as voltage drops across each resistor. If at any time the voltage reading equals system voltage, that resistor leg has failed. Hope this helps!
power source conductor resistor switch
You actually can play Combat Arms with a controller. But it has to be a(n) XBox 360 controller since it has a USB slot. But you may have to set up the controls. I recommend using the basic mouse and keyboard, the Controller is more difficult and harder to control.
basic electronic is basically a combination of basic electronics component like charge,battery,voltage current, circuit,resistor,ohm's law,power,capacitor,inductor,semiconductor
žManipulator žController žEnd Effector žSensors žEnergy source
Ha-ha I don't know.. listen to the teacher next time!
If it worked only on two positions for a while and no not at all. check to see if there's voltage at the blower connection, if there is 12v then it could be the relay, blower motor resistor or switch. Don't forget the basic, check fuse. The relay us usually located under the passenger side dash, next to steering column and flasher relay. on some Chrysler's, the resistor is located in the engine compartment on passenger fire wall.