0
Do the motor have to be lifted to change the crankshaft sensors on a 2001 cadillac deville northstar 32 valve?
Wiki User
∙ 15y ago
no it does't
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position senor located on a 2003 Cadillac deville?
where is the 2003 Cadillac Deville Crankshaft Position Sensors located
Where are the O2 sensors on a 1996 Cadillac Sedan Deville smaller Northstar engine?
there is one before and one after the catalytic converter.
How many oxygen sensors are in 2004 cadillac deville?
Three
Why does your 2001 Cadillac Seville shut off and turn back on?
check for the camshaft/crankshaft sensors... where is your camshaft/crankshaft sensors
How many oxygen sensors on a 1996 Cadillac sedan de ville?
I have a 1996 cadillac deville concours, an it has 4 oxygen sensors
How many sensors are in the 1979 Cadillac coupe deville?
too many!
How many oxygen sensors in a 99 cadillac deville?
Should be two front and rear of engine
Where are the oxygen sensors located on a 1991 Cadillac deville?
The 1991 Cadillac Deville oxygen sensors are located on the firewall and the air cleaner housing. The firewall oxygen sensor will be on the drivers side. The air cleaner oxygen sensor will be on the back of the air cleaner housing.
Where are the oxygen sensors on a 2001 deVille Northstar?
you have three oxygen sensors, 2 on the front and rear exhaust manifolds, right past where the pipes are connected together. and one by the catlyc converter good luck paul g
Where is the vehicle speed sensor on a 1997 Cadillac Deville besides the one in the transmission?
the four wheel bearing/hubs are speed sensors for the abs system.
What should you do if your Cadillac DeVille 92 service engine appears but never goes away even if you changed the sensors?
It is probably your egr valve that needs replaced!
Where is the Bank 1 Sensor 1 O2 sensor on 1996 Caddy Sedan Deville small Northstar engine?
The Northstar engine uses two O2 sensors. Sensor 1 is located on a bung in the exhaust after the manifold, but before the catalytic convertor. Sensor 2 is located after the catalytic convertor. It's that simple.
