I replaced my whole top with a one piece top with plastic rear window. It only cost $246 on eBay and it came with all the instructions I needed. It took me a weekend to do and it was easier than I thought. The only disadvantage of the one piece top, which I didn't find out until it was installed, is that it doesn't fit as well into the "boot" when open and the boot cover won't quite fit.
black window spider images
Dealer
the hcl for vista.....
need instructions on replacing window regulator
usually by replacing window regulator.
needs a new window motor and regulator
Smash a window or call a locksmith.
When replacing a window, be sure to take measurements carefully. Make sure the new window obtained will fit in the existing frame. It is best if there is a professional to replace the window.
The most common window problems in a 2007 Sebring are the fuse, the relay, the switch, and the motor. Check the fuse and the relay. If they are ok then the door will have to have the panel removed to reach the switch and motor.
when replacing motor what position does the window need to be in?
The bracket snaps on the window over the plastic pin in the window. You need to pull the bracket away from the window to get it down and over the plastic pin. If you will be replacing the window regulator you can just cut the bracket where it snaps over the pin.
eazy first peel the entier window off. you have to tkae the cover off. (under the back window.) Then get a tube of caulking from your local hardware store caulk the rag top set window in and block up the window the key to a none leakey window is to keep presser on the window. after dry put cover back on and trim excess. I hope this answer's your question i used duct tape, it works