Asked in Ford
Do you have to remove the oil pump to put in the pump rod or can you just slide it in the distirbutor and put it in on a ford 302?
October 10, 2008 4:23AM
Better pull the pan and oil pump. The rod will fall out while you are trying to align the dist. and cam gear. You won't know it till its too late. You will ruin the engine the second it starts.
Asked in Ford F-150, Radio
How do you remove the factory radio from a 1997 f150?
How do you remove a relay fuse Ford Expedition?
How do you replace 1998 ford crown Victoria head light assembly?
Asked in Chevy Camaro
How do you remove the headlights and covers from a 1999 camaro?
Asked in Starters and Ignition Systems, Ford F-150
How do you replace the ignition coil in a 2000 Ford F-150?
Asked in Ford Focus
What size is the retaining nut on Ford Focus front discs?
Asked in Nissan Altima
How do you remove front rotors on a 2004 Nissan altima?
Asked in Ford Escort LX
How do you remove 1991 Ford Escort stereo?
Asked in Ford Crown Victoria
Remove headlight assembly 96 crown vic?
Asked in VW Vanagon
How do you remove sliding door track cover on a vw vanagon?
You need to remove the sliding door, then remove the screws from the bottom of the track, then remove the screw from the front of the track and slide the cover forward. There is a bar that pinches the metal from the cover and locks it in the channel. You need to slide the cover forward to unlock it then it just pops out.
Asked in Brake Pads and Rotors, Ford Aspire, Ford F-150
How do you remove the front disc brake rotors from a '96 Ford Aspire?
Asked in Car Batteries, Buick Century
What is the best way to get the battery out of a 1996 Buick Century when it does not slide out?
How do you replace 1997 ford thunder bird headlight?
Asked in Smith and Wesson, Hunting and Shooting
How do you disassemble a smith Wesson model 459 pistol?
Remove the magazine and clear the chamber. Make sure the gun is NOT loaded. Set the safety in the up "fire" position. Pull the slide back just enough so the slide catch notch in the bottom left side of the slide is even with the front of the slide catch. If you pull the slide back far enough to engage the slide catch you have gone too far. When the notch in the slide is over the pin of the slide catch push on the pin from the right side of the frame. The button like end of the pin is just above the trigger on the right side of the frame. Push in this "button" you may need something like a pen if you cant push it with you finger. Fully remove the pin from the frame. Pull the slide forward out of the frame. Carefully remove the recoil spring and guide. Rotate the barrel bushing to the left and remove from the slide. Pull the barrel up and out of the slide. This is the standard field strip for this gun. Refer to a gun smith for further disassembling.
How do you remove the headrest from a 2002 ford focus?
Asked in Ford F-350
Does the brake caliper on a 1990 f 350 4x4 single wheel just pop off?
Asked in Ford Thunderbird
How do you remove door panel from 1988 Ford Thunderbird?
there are 2 screws (1 at each end) behind little snap in covers on the pull handle, remove them. 2 more i think where the handle you open the door is at, the rest should just be held by plastic studs that are just pressed into the door.you just slide a flatbar between the panel and door and pry them out. though it usually tears them up removing them.
How do you remove the battery on a 1987 suzuki intruder?
How do you remove the radio out of a 1989 Mercedes 260e?
How do you remove the rear brake drums on a 1999 Ford F-150?
Remove the wheels then the drums should just slide off. If they are rusted on, WD40 and a hammer should do it. If the shoes have scored the drums, you have to retract the shoes first. If you can't do that you can pry the drums off and ruin the springs and fittings. You have to replace them and know how they go if you do that.