To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
This is not for beginners. You have to drain the transmission, remove the axles, remove the transmission, install the new cylinder, then replace the transmission, axles, add new synchromesh fluid to the tranny, and bleed the clutch hydraulics. You can get the whole procedure from Autozone's website.
You will need to remove the transmission to replace the clutch slave.
YES you do. It's all in the bell housing. No other way to get to it.
YES. It will have 3 bolts that hold it in place in the bell housing. Must remove transmission to service.
You will need to remove the transmission and you will find it in the bellhouseing. There will be 4 10mm bolts that hold it on,
You will have to REMOVE the transmission and when you look in the bell-housing you will see the slave cyclinder. Remove the 4 bolts that hold it in place and replace it.
It is inside of the transmission bell housing. You will have to remove the transmission to service it.
You must remove the transmission are engine to replace the rear main seal.
The transmission must be removed, and put back in, not replaced.
Remove carburator then intake manifold then cylinder heads
this site will help