0
What else can I help you with?
Where is the bleeding nut for the clutch on a Hyundai excel?
The bleeding nut for the clutch on a Hyundai Excel is typically located on the clutch slave cylinder, which is situated on the transmission near the engine. To bleed the clutch, you will need to access this nut, usually found on the side of the slave cylinder. Make sure to have a helper to pump the clutch pedal while you open and close the bleeding nut to remove any air from the system. Always consult the vehicle's manual for specific details and procedures.
What are the roles of friction and gravity in the car?
Friction in cars are produced by the tires and the clutch. The friction caused by the tires allow the vehicle to stay on the road, while the friction produced by the clutch makes it possible for the car to get moving. While gravity, for example supplies the force that pulls the vehicle down the hill.
WHERE do you fill clutch flu ed Mazda e2000 van?
We have just had some probems with our Mazda E2000 Campervan, and needed to fill the clutch fluid. While we had some difficulty finding the reservoir, there is a reservoir near the steering wheel on the left. It says that it is for brake fluid, but it is also for the clutch. We bled the clutch and while bleeding it the reservoir where the brake fluid is store dropped confirming that this is also the clutch reservoir. Hope this helps.
Your clitoris is bleeding?
I would leave it alone for a while to heal up. if it doesnt as soon as you would expect, take it to a doctor.
If you just replaced the clutch master cylinder on a Nissan 240sx then why won't it build up pressure?
The most likely case would be that air somehow got into the line. try bleeding the clutch fluid, while making sure that the level in the reservoir does not get low.
How do you bleed the clutch system for a 1985 Nissan truck?
Down on the passenger side of the bell housing there is a cylinder looks a lot like a brake master cylinder this pushes the rod that engages the clutch have someone push the clutch pedal all the way down and hold while you loosen the bleeder on the clutch cylinder like bleeding brakes remember to check fluid level in reservoir good luck
Clutch Bleeding on a 2000 Suzuki Hayabusa?
To perform clutch bleeding on a 2000 Suzuki Hayabusa, start by locating the clutch master cylinder and identifying the bleed valve on the slave cylinder. Use a clear hose attached to the bleed valve, and open it while having an assistant pull the clutch lever to push fluid through the system. Keep an eye on the fluid level in the master cylinder reservoir to prevent air from entering, and repeat the process until clear fluid without bubbles flows out. Finally, close the bleed valve, top off the reservoir, and test the clutch lever for proper feel and engagement.
How do you put clutch fluid in Toyota celica 92 it leak out from hole in the hose an clutch went to floor so how to get clutch up?
First, you need to repair or replace the hose that is leaking. Then you need to fill your clutch master cylinder with fluid. Then you need to bleed the clutch to remove all the air in the line to get the pressure back in the pedal. Bleeding the clutch takes two people to do it. While one pumps and then holds the pedal down while the other releases the air from the valve on the slave cylinder. Repeat the pump and hold on the pedal until all the air has been purged from the system, make sure you keep refilling the clutch master cylinder with fluid during this procedure.
How do you bleed the clutch sistem in a fiero car?
best way is gravity flow.jack up frontend.take off cap to resovor and go drink a six pack while u wait.
Your dogs pad on her foot keeps bleeding and im afraid I will wrap it to tight how can you stop this bleeding?
if it is just a small bleed then put water on it and leave it alone for a while and if it is a big bleed then wrap it gently and take the dog to the vet.
1978 corvette new brake system you have good pedal after bleeding system but pedal fades almost to floor when the car is running you tried bleeding the brakes while the engine was running and gravity?
I would suspect the Master Cylinder if defective. I had the same problem with my 1978. I replaced the combination valve and it solved the problem after bleeding.
Can you get pregnant while slightly bleeding from a miscarriage?
No you can't get pregnant while slighty bleeding fro a miscarriage!
