Want this question answered?
Remove the head, Grind it flat and replace it using a new gasket.
Head gaskets are supposed to last the life of the engine. There is no "care" specific to head gaskets.
There are many gaskets on any car engine. If you are asking about head gaskets, they are between the cylinder head(s) and the engine block. The cylinder head is under the valve cover. --------------
If you have to ask do not attempt it!!! If you make even the smallest mistake you will destroy your engine.
There are ( 2 head gaskets ) one head gasket for each head on your V6 engine
Remove the cylinder head from your 1992 Chevy 350 cubic inch engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
Between the head and the engine block.
You will need to remove the cylinder heads from your Ford F1 50 pickup truck engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
if the miles on the engine aren't too high, then just replace the head gaskets. if the whole engine is tired go ahead and swap out the motor. its a lot cheaper to do the gaskets then to buy a new motor.
do you have to remove lifters on heads in order to replace gaskets? No only the puch rods if it is a non overhead cam engine,
No
There are two head gaskets in the V 8 1999 mercury mountaineer