It depends on the condition of the belt(s) and how recently it (they) have been changed. If you're certain that the belt was changed recently and is in good condition you could probably get by without replacing it (them)
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
Remove the belt from your 1998 Chrysler Town and Country alternator. Disconnect the wiring from the alternator. Loosen and remove the alternator retaining bolts. Reverse the process to put the new alternator on.
the alternator + replacing fees lies between $350-$400 if the alternator is remanufactured (not brand new). The cost may reach $600 if it is brand new
how much should a minivan battery cost to replace 2008 Chrysler Town and Country
how to replace a 1998 Mazda millenia alternator
were should i satart when replacing the alternator in a Volvo s70 1998 were should i satart when replacing the alternator in a Volvo s70 1998
you need to replace the alternator
There are three main steps behind replacing the alternator on the 1998 Chrysler Concorde. The first is disconnecting the battery cables for safety. Second, is depressing the belt tensioner to allow for the release of the drive belt. Finally the alternator can be unbolted from its bracket for replacement. If the drive belt, idler pulley and tensioner are worn it would be an ideal time to replace this components as part of the install.
The alternator on a Chrysler 300m can be replaced by disconnecting the battery, removing the wiring harness from the alternator, and then unbolting it from the mounts. The drive belt can then be slipped off and a new alternator put into place.
The cost to replace the engine in your Chrysler Sebring will range between $2000 and $6000. Replacing with a used engine will be the cheapest and replacing with a brand-new engine will cost the most.
Only when it fails. 250,000 miles would be average.
disconnect the battery. Remove the alternator belt then disconnect the wires. Unbolt the alternator and remove. Bolt the new alternator in then connect the wires, belt, and battery.