If the load is rated 220 or 230 or 240 volts (all the same thing), and specifies a wattage rating, that wattage rating is at the double pole voltage. You wouldn't make any adjustments to it.
The load should also indicate the input current in Amps, which is used for sizing your breaker. If not, watts=amps x volts, so amps=watts/volts.
For example, a 3800 Watt heater at 240v would require 15.83 amps. The breaker for this circuit would be 125 percent of that (safety factor), or 20 amps, 2 pole.
The number that is on a breaker is the amount of amperage that the breaker can deliver before it trips. This is the same regardless of how many poles the breaker is.
It is going to be split into two movies.
It's supposed to be split into 2 parts and I believe the first part is coming out on November 18, 2011. :)
Yes and it is 41/2 = 20.5
Split Screen - 1997 Animal Talent 2-13 was released on: USA: 7 September 1998
A single phase circuit uses a 2 pole breaker if the circuit is 120/240 split phase and the load is connected 240. Both legs are hot, so both need to be protected. This is the normal US/Canada configuration.
The term "double pole" usually means a breaker with 2 handles that attaches in the space as a normal single pole breaker. If this is what you mean, no, you cannot. There is no potential, or voltage, between the wire terminals. If by "double pole" you mean what is usually called a 2-pole breaker, which is a breaker with 2 handles that attaches in the space of 2 single pole breakers, then yes, you can use this breaker and 12/2 wire to produce a 220v circuit.
A pole In a circut breaker refers to the number of circuts it controls, single pole only controls one, double controls 2 at same time
can a 20 amp double pole circuit breaker be used for 2 different 120 v circuits using 14 - 2 wire
AWG 12/2 requires the use of a 20 amp single pole breaker.
If the breaker will snap on the bus bar, yes.
All three, on 110V a split receptacle, on 220V a baseboard heater, on 440V a construction heater or similar resistive load.
Probably
In America, a 2-pole breaker is controlling 240V. 120V per leg.
Yes.
If your breaker box will accept tandom breakers you can remove 4 single pole breakers add 2 tandoms this will empty 2 spaces for your 2 pole 30 amp for the dryer
2800 watts at 240 volts would give you the 80 percent derated ampacity. <<>> Without a voltage voltage being stated, an answer can not be given. Electric heaters are sized by wattage and are used on many different voltages. Wattage is the product of amps times volts. So as you can see without the voltage the question can not be answered.