answersLogoWhite

0

Not unless there is a possibility you will drill into some wiring.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you change battery in 2003 Pontiac Aztec?

Remove underhood fuse block (there is a bolt between the body panel and the fuse block housing), set it aside Remove body strut. Unhook negative cable, then positive cable. Loosen battery tie down bolt. Remove battery. Installation is reverse of removal.


How do you replace an IAC on a 1999 dodge ram?

Unplug the four wire connector on the back of the throttle body, remove two t25 torx screws. Swap actuator, reverse steps to install. Unhook battery for 5 minutes to reset idle adaptive memory.Unplug the four wire connector on the back of the throttle body, remove two t25 torx screws. Swap actuator, reverse steps to install. Unhook battery for 5 minutes to reset idle adaptive memory.


Whats causing 1989 Suburban to not start Fast clicks when trying to start battery is good and connections are good even bought new starter and even tried different battery still just clicking?

Check the wire from the battery to the body and from the battery/body to the engine block.


Just replaced battery 2003 silverado now idle is low?

clean the throttle body unhook both the batt. cables touch them together for 30 seconds hook batt back up and your good to go


Can you jump start a Ford Focus to focus?

sure connect the positive terminal directly to the booster battery and the negative battery terminal to the body


2005 grand caravan doorlock switch will not lock or unlock the doors?

take the van to the dealer and have the body computer up dated the easiest way to see if this will work is to unhook the battery and if the locks go back to working it will fix it


How do you reset check engine light on 1999 Chevy silverado?

If it is a early month of 99 and NOT the NEW body design then you can just unhook the battery cable for 5 mins. If it is the NEW body design 2000 and up, then that requires an OBDII engine scanner to turn the light out / Reset the computer.


We checked the fuse the relay and switch seems good on our 95 lumina but the horn is still not working Do you know what we should check?

Unhook your horn and hot wire it from the battery to see if it work. If only one wire is going to your horn that should be your hot wire so gound the negitive wire from the battery to your body.


Car wont start when you crank it up the battery meter goes down and lights go off?

Probably a bad ground from the battery to engine/body.


2002 s10 w 4.3 auto it was running fine was jumping off another truck n as soon as touched the cables it died n won't start again it spins over n spits a little through the throttle body?

unhook your battery for a half hour reconnect your cables you should be back in business. always shut off your computer controlled vehicle connect the cables and then start your vehicle. hope this helps.


How do you reset the computer in a 1988 Ford bronco 2 has new battery and still no power?

the bronco needs to have the ground wire connected from the battery to the body. if you replaced the battery and disconnected that ground it simply won't start.


How do you disconnect the alarm system for a 1998 Plymouth Van?

The factory alarm is built into the Body Computer. It is not possible to unhook it.