answersLogoWhite

0

1989 Dodge colt no start;noid light steady bright

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What causes the distributor not to fire to the spark plugs on a 1993 Plymouth colt?

A faulty ECM!!!


Where is the fuel filter located on 1993 dodge stealth?

on a 1993 Dodge Stealth rmove the battery plate and its on the left hand side on the fire wall towards the bottom.


Where is the ignition power transistor on a 94 dodge colt?

most likely it will be on the drivers side right up against the fire wall


What are the release dates for Home Free - 1993 Can't Start a Fire Without a Spark 1-9?

Home Free - 1993 Can't Start a Fire Without a Spark 1-9 was released on: USA: 18 June 1993


You have no fire on your 1991 Dodge colt what do you need to do to fix this?

do you have the electronic anti-thieft key inserted in the dash. this is located just to the left of the steering coloum


Why dodge avenger turns but does not start?

check the spark plugs. may not be catching fire.


Is a colt police positive 32 police ctg colt a rim fire or center fire?

more then likely it's a center fire. rim fire cartridges are hard to find.


Who is the founder of colt fire arms?

Samuel Colt in the middle 1800's.


What ammunition does a Colt 1911 fire?

The colt 1911 fires .45ACP ammunition.


Why wont my 94 Dodge colt 1.5L wont start got spark fuel to all the injectors sucking air timings bang on?

My colt would fire then die often. Run occasionally for a few minutes, then die. Ater replacing or cleaning everything. I found the MAP sensor was bad. Napa is the only parts store that has it. If you do a search for it on their web site you will see a picture of it.


1993 dodge Dakota will not fire?

I have a 1995 dodge Dakota that didnt fire either first go for the cheaper step and check the fuses if its not that check the crank shaft sensor that is what mine turned out to be. it was only 60 dollars for the part and 5 minutes of my time.


Why does a 1993 dodge conversion van 318 fail to start after it has been driven and brought up to tempIt has to sit for numerous hours before it will fire up after it was shut off while warm?

Take the coil off have it checked or replace it