Dodge ram1500 the trans does not go out of low one day it was fine and the next its stuck in low is their a switch or solenoid that you need to replace?
I had that happen to mine a sprag failed in the tranny but I AM ABLE TO SHIFT IT MANUALLY FROM A STOP AND CONTINUE TO DRIVE IT DAILY.
Yes the solenoid is built into the starter. unlike most starters, you can't just remove the solenoid and replace it, but the good news is that the solenoids are relatively cheap to have repaired, if you have a local rebuilder. most times you can rebuild the solenoid twice before having to actually replace the whole starter
Have a 1992 Dodge Ram 50 When you turn the key the lights on the dash come on but the starter does nothing you have had the Battery tested the starter tested you have replaced the ECM and Starter?
You should locate and test the solenoid. Most have three connections. There is a large cable from the battery to the solenoid, from the solenoid to the starter and from the start switch to the solenoid. The power terminals to the battery and the starter are large and have large cables. The starter switch connection is much smaller. Turning the key to 'start' provides a low current voltage to the solenoid causing the solenoid relay…
If the transmission solenoid pack is leaking it must be replaced. It can not be repaired. You replace the solenoid by removing the cooler hoses, the input speed sensor and the three bolts that hold the solenoid. remove the solenoid, clean gasket surface and reverse previous steps. Final step is to top off transmission fluid.