There is a reservoir for the hydraulic clutch under the hood , driver side just above the brake master cylinder reservoir. The clutch also has a bleeder valve on the driver side of the clutch bell housing.
full size K5 blazer in 83 does not have hydraulic clutch.
small little s-10 blazer does possibly, in 83 but may not until 85 also.,
you need to know which blazer you have,
little one or big one
they are TOTALLY different trucks.,
there was no hydraulic clutch in the full size trucks until 85, including the K5 blazer
A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.
Where is the control module located on the 1983 Chevy blazer
NO!
The same way you would for brakes. Pump the clutch 4 or 5 time and hold down then open the bleeder valve to release the air. Is it the 2.8L V6 motor?
The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.
If it does not have a Hydraulic clutch, then it has no fluid. If it has a Hydraulic clutch the clutch master cylinder is normally located on the firewall, driver's side, near the brake master cylinder.
The wiring diagram for a 1983 Chevy Blazer can be found in the service manual. It contains a detailed layout of where each wire goes and its function.
Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.
It does not matter on that year, as long as it is PS fluid.
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
There is NO adjustment. It is adjusted automatically through the hydraulic slave cylinder. Probley time for a NEW clutch kit.
Mazer Blazer - 1983 VG was released on: USA: 1983