0
Does a 1990 Volvo 240DL use a 1 wire alternator for a 12 volt system?
Jmadison
mikehunt
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the starter inhibitor switch on a 1990 Volvo 240dl?
Where is the starter inhibitor swith on a volvo 1993 260 GLE i ?
Why does a 1990 Volvo 240dl died after hearing noise thru radio and turning on headlights on?
Sounds like the charging system failed and the car ran until battery power was deleted.
How do you correct 1990 Volvo 240dl engine fault code 113?
Code 113 is a fuel injector fault code
Will a 1995 2.3 in a 1990 Volvo 240DL. What changes are required. The distributors are in different places?
There will be a Cam/Coil trigger sensor on one of them. if so, you'll need to upgrade the entire ICU system
Alternator wiring 1993 Volvo 240?
how can i repair a wirie taht has been broken from alternator to wiring harness on 1990 volvo 240?
What is the type of automatic transmission fluid for Volvo 240 1990?
Dexon IID, IIE, or III. Any Dexon III is fine, and it's what I use. -Bob, 1986 Volvo 240DL wagon
What causes alternator not to charge 1990 Volvo 240?
Worn brushes, bad Regulator, or Likely a bad connection or wiring.
Where can you find a diagram of a 1990 Volvo 740 vacuum system?
you can find it in a workshop manual
Is my alternator for a 1990 Volvo if when you take the positive cable loose and it cuts off or could it be the battery?
all alternators require battery power to operate.
Where is the fusible link for the alternator charging system on a 1990 mercury cougar?
I can tell you that on a 2000 mercury cougar it is a fuse on the positive cable between the battery and the alternator
How do you change the alternator belt on a 1990 Volvo 240?
First you've got to loosen the tensioner pulley bolt. Loosen both bolts as usual on the alternator and that should give you the slack to take it off. If its already off then to put on a new one.
How do you replace the alternator on a 1990 Subaru Loyale?
Remove the wiring harness from your 1990 Subaru alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
